Techno-economic-environmental evaluation of a combined tri and dry reforming of methane for methanol synthesis with a high efficiency CO2 utilization

Production of methanol, as a green energy, from syngas is coming into focus. However, natural gas based methanol plants, which are used steam reforming of methane for syngas production, have a high CO₂ emission resulting in the global warming. In this study, a novel process for methanol synthesis is proposed to reduce CO₂ emission. In this regard, natural gas and flue gas are fed to a parallel-series system with tri and dry reforming of methane for syngas production with the optimized stoichiometric number. Then, the produced syngas is converted to methanol in a reactor. Finally, the produced methanol is purified by two distillation towers. The proposed method is compared to a referenced method in the view of technological, economic and environmental metrics. The techno-economic-environmental analysis of the processes reveals that not only the proposed method, as compared to the referenced one, increases CO₂ conversion from 20.93% to 99.22%, but also it is more economical and environmentally friendly. In addition, the global warming potential of the proposed method is almost 60% lower than that for the referenced method due to the lower CO₂ emission. Therefore, the proposed method can save above MUS$ 8 a year by CO₂ capture.     

条形药包爆破震动场的试验研究

通过时条形药包周围实测爆破震动数据采用数值计算方法进行处理，作出了条形药包周围的爆破震动场，使我们对条形药包的爆破地震效应有了全面的认识，从而在实际工程爆破中能够有针对性地进行安全防护。分析研究认为：条形药包周围的震动场由一系列同心椭圆形等震线组成。在爆破近区由于位置因素的影响，等震线的长轴与药包轴线重合；在远区的震动主要受波动干涉作用的影响，致使长轴与药包轴线垂直，因此不能采用集中药包的计算方法。     

建筑结构控制爆破拆除的力学分析与应用

应用运动学、动力学理论建立建(构)筑物控爆坍落过程的力学模型,进而研究在非定常约束条件下坍落结构的力学特征。首次提出了采用延时起爆技术时,非自由质点系及其广义坐标应是建立在每一段位上的瞬间虚位移。在此基础上,分析求解运动过程中时控单元的质点自由度,为精确选定爆破部位及时序提供了设计理论和计算依据。同时,结合振动理论,将控爆时差、结构载荷分布调制为振动系统,形成坍落结构梁板单元的强迫振动,充分实现在运动中进一步解体、破碎其自身结构,并形成具有明显缓冲效果的下落过程。应用实践结果证明力学分析是正确的,为工程结构爆破拆除计算机辅助设计及动态模拟技术的有效应用奠定了基础。     

基于有限元法的石油射孔枪弹间干扰研究

石油射孔弹顺序起爆后,弹间冲击波相互作用是一个高度非线性的力学过程。基于有限元法对这一过程进行显式动力分析,由计算结果得知,高孔密射孔枪弹间干扰产生的主要原因是下位弹在不对称的压力场起爆。设计的不同孔密和不同爆速的导爆索两种情形的爆轰试验结果表明,弹间间距越小(即孔密的增加),弹间干扰越严重;随着导爆索爆速的降低,下位弹射流头部质量集中的"中间"偏转角度增大,上位弹对其干扰越明显。以上结论可用于高孔密射孔枪的优化设计。     

Directional separation of hydrogen-containing gas mixture by hydrate-membrane coupling method

Recovery of hydrogen (H₂) from H₂-containing gas mixtures has great significance for energy conservation, cost reduction and benefit increase. However, the common separation methods have the ubiquitous problem due to phase equilibrium principle and results in the conflict between H₂ concentration and H₂ recovery rate in the product gas. Consequently, an innovative conception of hydrate-membrane coupling approach is proposed in this work. In the separation process, hydration and membrane permeation two separation driving forces coexist to achieve the aim of strengthening mass transfer kinetics. H₂ and non-H₂ components (hydrocarbons) are synchronously and directionally selected by membrane and hydrate to improve different phase compositions. Therefore, the gas in feed side could keep relatively high two separation driving forces (H₂ fugacity and hydrocarbons fugacity). The results show that the coupling method could synchronously increase both the concentration and the recovery rate of H₂ in the product gas. At the same time, the volume and concentration of the hydrocarbons in hydrate both increases effectively. It indicates that hydrate and membrane separation methods support each other in the separation process. The hydrate-membrane coupling method fundamentally solves the issue of the decreasing driving force resulting from single separation method and phase equilibrium relationship.     

Use of La2O3 with 8YSZ as thermal barrier coating and its effect on thermal cycle behavior,microstructure, mechanical properties and performance of diesel engine operated by hydrogen-algae biodiesel blend

In this present work, the effect of lanthanum oxides (La₂O₃) on the thermal cycle behavior of TBC coatings and mechanical properties such as adhesion strength and microhardness of 8% Yttria Stabilized Zirconia (8YSZ) TBCs were investigated. CoNiCrAlY and aluminium alloy (Al–13%Si) were used as bond coat and substrate materials. 8YSZ and different wt % of La₂O₃ (10, 20, and 30%) top coatings were applied using the atmospheric plasma spray (APS) method. The thermal cycling test for TBC coated samples were conducted at 800 °C in the electric furnace. The XRD pattern shows that the La₂O₃ doped 8YSZ material transformed to cubic pyrochloric structured La₂Zr₂O₇ during thermal cycling. Further, the Taguchi-based grey relation analysis (GRA) method was applied to optimize the TBC coating parameters to achieve better mechanical properties such as adhesion strength and microhardness. And the optimized La₂O₃/8YSZ TBC coating was coated on CRDI engine combustion chamber components. The engine was tested with microalgae biodiesel and hydrogen, and the results were promising for the TBC-coated engine. The engine performance increased while using La₂O₃/8YSZ coated components, and the emissions from engine exhaust gas such as CO, HC, and smoke reduced considerably. It was found that there was no separation crack and spallation of the coating layer in the microstructure. Ultimately, the microstructural analysis of the optimized TBC coated piston sample after 50 h of running in the diesel engine confirmed that the developed coating had a superior thermal insulation effect and longer life.     

Effects of non-thermal plasma treating wheat kernel on the physicochemical properties of wheat flour and the quality of fresh wet noodles

The effects of non-thermal plasma (NTP) on the physicochemical properties of wheat flour and the quality of fresh wet noodles ( FWN) were investigated. The results showed that NTP effectively decreased the total plate count (TPC), yeast and mould count (YMC) and Bacillus spp. in wheat flour. Wet gluten contents and the stability time reached the maximum when treated for 20 s. The viscosity of starch increased significantly after treatment due to the increased of damaged starch. The contents of secondary structure were altered to some extent, which was because that the ordered network structure of gluten protein broken. Furthermore, compared with the control, texture properties of FWN were enhanced significantly at 20 s, and the darkening rate of FWN was greatly inhibited due to the low polyphenol oxidase (PPO) activity. Consequently, the most suitable treatment was 500 W for 20 s, providing a basis for the application of NTP in flour products.     

Cheese ripening in nonconventional conditions: A multiparameter study applied to Protected Geographical Indication Canestrato di Moliterno cheese

A multiparameter study was performed to evaluate the effect of fondaco, a traditional ripening cellar without any artificial temperature and relative humidity control, on the chemical, microbiological, and sensory characteristics of Protected Geographical Indication Canestrato di Moliterno cheese. Ripening in such a nonconventional environment was associated with lower counts of lactococci, lactobacilli, and total viable bacteria, and higher presence of enterococci, in comparison with ripening in a controlled maturation room. Moreover, fondaco cheese underwent accelerated maturation, as demonstrated by faster casein degradation, greater accumulation of free AA, and higher formation of volatile organic compounds. Secondary proteolysis, as assessed by liquid chromatography-mass spectrometry of free AA and low molecular weight peptides, did not show any qualitative difference among cheeses, but fondaco samples evidenced an advanced level of peptidolysis. On the other hand, significant qualitative differences were observed in the free fatty acid profiles and in the sensory characteristics. Principal component analysis showed a clear separation of the fondaco and control cheeses, indicating that ripening in the natural room conferred unique sensory features to the product.     

Western Canadian dairy farmers' perspectives on the provision of outdoor access for dairy cows and on the perceptions of other stakeholders

The provision of pasture and outdoor access for dairy cattle differs around the globe. For example, in Ireland, New Zealand, and Australia, dairy farms are largely pasture based, whereas dairy farms in the United States and Canada are largely confinement based. There is a high level of public support for pasture and outdoor access for dairy cows, and the available evidence shows that dairy cattle are highly motivated to access pasture, especially at night. The decision as to whether to provide outdoor access is typically made by farmers, but little is known about dairy farmers' perspectives on this topic. We investigated perspectives of Western Canadian dairy farmers on outdoor access, as well as how they believe different stakeholders (i.e., the dairy industry, the dairy cows, and the general public) regard outdoor access for dairy cows. Data were collected via (1) 11 focus group discussions with a total of 50 Western Canadian dairy farmers, and (2) semi-structured individual interviews with an additional 6 dairy farmers of Hutterite colonies. Data were analyzed using template analysis. Although most participants in this study did not provide outdoor access on their farms, or only provided outdoor access to certain cow groups, participants generally mentioned that they enjoyed seeing cows on pasture or outdoors. However, participants shared that the Canadian supply management system (including processors) required a consistent flow of production, which was thought to be easier and more economically realized with indoor housing of lactating cows. Participants believed that pasture or outdoor access for dairy cows was desired by the public. Some participants believed that dairy cows prefer to spend time outside under favorable weather conditions, but others felt that cows preferred to stay indoors in modern, ventilated freestall barns. The results of this study describe the perspectives of dairy farmers regarding the views of dairy industry stakeholders as they relate to outdoor access, helping to inform conversations around the provision of outdoor access for dairy cattle.